I used both dongles last night (GMB Measure Tool and Monaco PROFILER)
and it didn't seem to be a problem, even through a tiny USB hub that I
have.
I'm also running a MacBook Pro (15"). One possible difference is that
I did a simple "Upgrade" install of Leopard instead of an "Archive and
Install" installation.
One thing I did before I started the install was boot from the Leopard
DVD and run Disk Utility. I first ran Disk Repair (twice) until it
gave me a clean bill of health and then ran Repair Permissions until
it was clean also. Don't know if that helped but it did make *ME* feel
better!
You tried both USB ports? For some reason, I get some general
flakiness through the USB port next to the power supply connection but
not on the USB port on the other side. Go figure.
Regards,
Terry Wyse
On Nov 2, 2007, at 11:06 AM, Derek Lambert wrote:
Does anyone have problems recognizing Monaco Profiler and Gretag
ProfileMaker dongles under Leopard?
I installed Leopard on external drive to test it and My MacBookPro
doesn't recognize either dongle (no light).
