Sorry I didnt clarify. This is an Xserve RAID. They are the two
controllers and on the one side I have an existing RAID 5 array.
On the other side I put in 4 more disks and am formatting them as a
raid 5 set as well.
I would like one Xserve to access the array on one side and the
other Xserve to access the array on the other side exclusivley. No
Xsan is involved.
<snip>
Okay easy.
thats the default config setup.
configure you controller in raid admin.
then create an array go through steps 1 through 3
you'll have 2 RAID level 5 sets ( thats default out of the box )
plug in your fiber channel cables one to each xserve. boot the xserve
first then the RAID. it should mount as a big fat drive.
