I'm runing Tiger server with latest patches, I've enabled both
interfaces, one being on the university's official network, the other
on a private gigbit network which connects all servers (no gateway, no
router) on their second interfaces.
I wanted to enable DHCP on both interfaces, where each interface
serves different IP networks. The 'Server Admin' application provides
checkboxes to select the interfaces for which the service is to be
available. You can enter different network addresses and ip ranges,
and you can successfully start the service.
However, when I look into the log files (and try out the services on
the different networks), only ONE network is serviced, never both. If
I select either one (but not both) interfaces, all is fine for the
corresponding IP address.
Is this a feature, or a bug? Anyone else noticed this?
Departement Informatik FGB tel +41 (0)61 267 14 66
Universität Basel fax. +41 (0)61 267 14 61
Robert Frank
Klingelbergstrasse 50 email@hidden
CH-4056 Basel
Switzerland
http://www.informatik.unibas.ch/personen/frank_r.html
_______________________________________________
Do not post admin requests to the list. They will be ignored.
Macos-x-server mailing list (email@hidden)
Help/Unsubscribe/Update your Subscription: http://lists.apple.com/mailman/options/macos-x-server/
email@hidden
This email sent to email@hidden
I had been able to do exactly what you are talking about on a 10.3
Server. However, I ran into the same problem when I tried setting up a
new test server running 10.4 Server. I final got fed up enough with
trying to do in manually, that I ran Apple's "Gateway Setup Assistant".
Although it did things a little bit differently than I wanted, it did
work, then I went in and tweaked the settings that the assistant had
made so that they were closer to my liking. Just a note, NAT had to be
turn on (the assistant turned it on by itself) for all this to work.
After I had the system working with 2 NICS (Built-in and 1 PCI) I
decided to see how well the assistant would work. I threw two more NICs
into the system (G4 Tower) and ran the assistant again. Once again I
needed to go in and tweak the settings but it worked. I had four
separate subnets working and communicating properly with one another
(including three PCI NICs plus the built-in ethernet). I still don't
know what all Apple has changed, but I do know that the assistant seems
to be a viable work around until it's figured out.
Robert Marking
Technology Support Specialist
Stillwater Jr. High School
523 West Marsh Street
Stillwater, MN 55082
651.351.8910
651.351.6999 fax
email@hidden
