Are there known issues with incoming channels? I'm having a problems which seems to be my incoming channel and my application getting "out of sync". Here's how things go when it works: I have a Bluetooth tablet. When my application starts, it sets up an incoming channel. I then use my application to establish a connection to the tablet. When it connects, my application transmits my local Bluetooth address to the tablet. The tablet stores that address. The tablet has a "Link" button that, when pushed, attempts to connect to the Bluetooth device corresponding to the address that it has stored. Usually, this works great. I can connect to a number of tablets, have my BT address transmitted to each one, and from that moment on, use the Link button on the tablets to re-establish connection to my application when desired. But there's two circumstances where the process gets hosed. First, if I attempt to connect to a tablet, but the tablet is off (and thus the connection attempt fails,) and then I turn the tablet on and hit the Link button to establish the connection from the device to the application, the tablet goes through its connection attempt cycle (about 10 seconds) and fails. And it continues failing each time I try it after that. Second, if my application unexpectedly quits (and thus never calls IOBluetoothRemoveServiceWithRecordHandle or unregister) and I start it up again and try to hit the Link button on a tablet to establish a connection, the tablet doesn't connect. But then if I exit my application (which goes through the the normal exit routine and removes the service) and restart it, I immediately get the incoming connection from the tablet, even though the tablet stopped trying to connect already and thinks that the connection failed. It's like the incoming channel is still open, and the tablet really does connect to it, but the connection between my application and the incoming channel is broken, so I never get notification of an incoming connection, until I restart the application, and then it apparently re-establishes connection to the incoming channel. Is there something about a failed connection attempt that screws up the incoming RFCOMM channel? ...Eric Crichlow... ...GTCO CalComp... _______________________________________________ bluetooth-dev mailing list | bluetooth-dev@lists.apple.com Help/Unsubscribe/Archives: http://www.lists.apple.com/mailman/listinfo/bluetooth-dev Do not post admin requests to the list. They will be ignored.