Some questions regarding i1 Profiler. When reading a target, RGB, regardless of which line I read, the software does not register the corresponding line. It does not tell me I have read the wrong line for, let's say, line 3. I can read line 12, and if line 3 was the next one, it thinks I am reading it, the software is happy. I says read line 4 Does not tell me I have read the wrong line. I have seen strange looking green profile shapes in .icc profile. Reading just one canvas, three times has given me different looking green shapes. I have no idea what is going on. I have seen this once before, so I reprinted the target and all was fine. I can send screen shots if screen shots would help. Information on the target. 1260 patch chart, 12.8 x 23.7 inches. Unscrambled. Epson Pro 9600 print driver, MBP4.1, 17 inch, os 10.6.7. I have used both the i1 Pro revision D and revision A. Normally I use revision D. But was wondering if Revision would give the same results. And it did. Thank you for your prompt consideration and response. Sincerely, David B. Miller, Pharm. D., member Millers' Photography L.L.C. 3809 Alabama Street Bellingham, WA 98226 360 739 2826 digitalimaging@dnmillerphoto.com