site_archiver@lists.apple.com Delivered-To: darwin-dev@lists.apple.com I am not completely sure this is the correct list, but ... I have an application that uses enough memory (Gigabytes) that it sometimes slows way down because of swapping. I'd like to be able to tell the user when that happens, so the user will not give up in disgust. My application is threaded, and the swapping generally takes place in one particular thread, so I could in principle have another thread monitor and report. But I am not familiar enough with low-level Unix memory-management stuff to know whether there is any way to track what is going on, or even where to start to look. Can anyone offer advice or suggestions? (The application's design pattern is model-view-controller. The model is in one thread; it is pretty much straight C++, and that's where the swapping takes place. The view and controller use another thread or two; They are pretty conventional Cocoa/Objective-C/Interface-Builder, and that's where it would be easiest to track swapping and report to the user.) Thanks. -- Jay Reynolds Freeman --------------------- Jay_Reynolds_Freeman@mac.com http://web.mac.com/jay_reynolds_freeman (personal web site) _______________________________________________ Do not post admin requests to the list. They will be ignored. Darwin-dev mailing list (Darwin-dev@lists.apple.com) Help/Unsubscribe/Update your Subscription: http://lists.apple.com/mailman/options/darwin-dev/site_archiver%40lists.appl... This email sent to site_archiver@lists.apple.com