site_archiver@lists.apple.com Delivered-To: pro-apps-dev@lists.apple.com Hi Steve, - Paul On Aug 20, 2009, at 3:00 PM, Steve Christensen wrote: Any thoughts? steve _______________________________________________ Do not post admin requests to the list. They will be ignored. Pro-apps-dev mailing list (Pro-apps-dev@lists.apple.com) Help/Unsubscribe/Update your Subscription: http://lists.apple.com/mailman/options/pro-apps-dev/pschneider%40apple.com _______________________________________________ Do not post admin requests to the list. They will be ignored. Pro-apps-dev mailing list (Pro-apps-dev@lists.apple.com) Help/Unsubscribe/Update your Subscription: http://lists.apple.com/mailman/options/pro-apps-dev/site_archiver%40lists.ap... We didn't intentionally increase our OS or XCode requirements, but this may have happened inadvertently. Can you send the full build transcript with the linker errors? You can just send it to me rather than the whole list. I just downloaded and installed the FxPlug 1.2.4 SDK. When I tried to rebuild some existing projects, I was getting "unknown load command" linker errors. When I backed down to the 1.2.3 SDK, the build worked as expected. I did the build on a 10.4.11 system running Xcode 2.5. (My plugins run on 10.4.x and later so I prefer to build/test in that configuration.) I suspect the issue to be either that 1.2.4 expects 10.5 and/or the linker commands are only valid for Xcode 3.x. I looked through both the 1.2.4 ReadMe and the SDK Overrview PDF but didn't see any build/ runtime restrictions. If there is at least a minimum OS requirement for the 1.2.4 SDK, the installer should do a check and refuse to install on earlier systems. This email sent to pschneider@apple.com This email sent to site_archiver@lists.apple.com