Re: How to get IPv6 address using getifaddrs and which version of glibc supports
Re: How to get IPv6 address using getifaddrs and which version of glibc supports
- Subject: Re: How to get IPv6 address using getifaddrs and which version of glibc supports
- From: almisr <email@hidden>
- Date: Sat, 5 Aug 2006 19:04:08 +0200
results given by your prog
Natacha:~ mmm$ ./prog
lo0: 127.0.0.1
lo0: ::1
lo0: fe80:1::1
en0: fe80:4::203:93ff:fe7c:3764
en0: 192.168.0.8
Natacha:~ mmm$ ifconfig
lo0: flags=8049<UP,LOOPBACK,RUNNING,MULTICAST> mtu 16384
inet 127.0.0.1 netmask 0xff000000
inet6 ::1 prefixlen 128
inet6 fe80::1%lo0 prefixlen 64 scopeid 0x1
gif0: flags=8010<POINTOPOINT,MULTICAST> mtu 1280
stf0: flags=0<> mtu 1280
en0: flags=8863<UP,BROADCAST,SMART,RUNNING,SIMPLEX,MULTICAST> mtu 1500
inet6 fe80::203:93ff:fe7c:3764%en0 prefixlen 64 scopeid 0x4
inet 192.168.0.8 netmask 0xffffff00 broadcast 192.168.0.255
ether 00:03:93:7c:37:64
media: autoselect (100baseTX <full-duplex>) status: active
supported media: none autoselect 10baseT/UTP <half-duplex>
10baseT/UTP <full-duplex> 10baseT/UTP <full-duplex,hw-loopback>
100baseTX <half-duplex> 100baseTX <full-duplex> 100baseTX <full-
duplex,hw-loopback> 1000baseT <full-duplex> 1000baseT <full-duplex,hw-
loopback> 1000baseT <full-duplex,flow-control> 1000baseT <full-
duplex,flow-control,hw-loopback>
fw0: flags=8822<BROADCAST,SMART,SIMPLEX,MULTICAST> mtu 2030
lladdr 00:03:93:ff:fe:7c:37:64
media: autoselect <full-duplex> status: inactive
supported media: autoselect <full-duplex>
_______________________________________________
Do not post admin requests to the list. They will be ignored.
Darwin-dev mailing list (email@hidden)
Help/Unsubscribe/Update your Subscription:
This email sent to email@hidden