Re: How to obtain measurement unit setting
Re: How to obtain measurement unit setting
- Subject: Re: How to obtain measurement unit setting
- From: mark <email@hidden>
- Date: Thu, 30 Dec 2004 10:21:14 -0800
Where is "AppleMeasurementUnits" defined? I saw it mentioned in the
document, but I couldn't see it defined in any headers (XCode 1.5, 10.3).
Where should I be searching?
Thanks!
mark
> From: Ricky Sharp <email@hidden>
> Date: Tue, 28 Dec 2004 12:47:01 -0600
> To: Ricky Sharp <email@hidden>
> Cc: email@hidden
> Subject: Re: How to obtain measurement unit setting
>
>
> On Tuesday, December 28, 2004, at 12:44PM, Ricky Sharp <email@hidden> wrote:
>
>> I've been unable to figure out what key is needed to obtain the measurement
>> units (US or Metric) as can be set in the International prefs panel (this is
>> under Panther/10.3.7).
>
> Figures...just found it after I sent this e-mail.
>
> The key to use is AppleMeasurementUnits. I found it while reading the
> following which mentions how NSRulerView honors the measurement units:
>
> <http://developer.apple.com/documentation/Cocoa/Conceptual/UserDefaults/Concep
> ts/DefaultsDomains.html>
>
> Sorry for the noise,
>
> --
> Rick Sharp
> Instant Interactive(tm)
>
> _______________________________________________
> Do not post admin requests to the list. They will be ignored.
> Cocoa-dev mailing list (email@hidden)
> Help/Unsubscribe/Update your Subscription:
>
> This email sent to email@hidden
_______________________________________________
Do not post admin requests to the list. They will be ignored.
Cocoa-dev mailing list (email@hidden)
Help/Unsubscribe/Update your Subscription:
This email sent to email@hidden