Re: silly question about build/release
Re: silly question about build/release
- Subject: Re: silly question about build/release
- From: "Clint Shryock" <email@hidden>
- Date: Wed, 18 Apr 2007 09:19:21 -0500
Jay-
Andrew suggested you do a "release" build. did you try that? it's not the
same as simply unchecking zerolink.
with the project open, select "project", then select "set active build
configuration", and set to "release" instead of "debug"
then hit build again
hope that helps
+Clint
On 4/17/07, Jay <email@hidden> wrote:
Thanks for your further explanation, not for this case, all machines are
PowerPCs, but I'll still look into it to make sure if I really make no
mistake.
Thanks a lot!~
Jay
----- Original Message -----
From: "Shawn Erickson" <email@hidden>
To: "Jay" <email@hidden>
Cc: "Michael Novak" <email@hidden>; <email@hidden>
Sent: Wednesday, April 18, 2007 10:35 AM
Subject: Re: silly question about build/release
>
>
> On Apr 17, 2007, at 5:53 AM, Jay wrote:
>
>> I checked with zero link option, for my case, even I did not use zero
>> link foe debug, it still fails to work on other machines...
>
> Debug also by default only builds the architecture for the system you
> build on.
>
> So if you build on an Intel system and give that application to someone
> using a PowerPC system it wont run however if you build on a PowerPC
> system and give it to someone with an Intel system it likely will run
> using Rosetta.
>
> -Shawn
>
_______________________________________________
Cocoa-dev mailing list (email@hidden)
Do not post admin requests or moderator comments to the list.
Contact the moderators at cocoa-dev-admins(at)lists.apple.com
Help/Unsubscribe/Update your Subscription:
This email sent to email@hidden
_______________________________________________
Cocoa-dev mailing list (email@hidden)
Do not post admin requests or moderator comments to the list.
Contact the moderators at cocoa-dev-admins(at)lists.apple.com
Help/Unsubscribe/Update your Subscription:
This email sent to email@hidden