Re: Release build wrong executable name, but debug build it correct
Re: Release build wrong executable name, but debug build it correct
- Subject: Re: Release build wrong executable name, but debug build it correct
- From: David <email@hidden>
- Date: Tue, 30 Sep 2008 17:31:53 -0400
I was looking under the project properties not under target
properties. Product name was set to the old value.
Thanks!
On Tue, Sep 30, 2008 at 5:16 PM, Mark Dawson <email@hidden> wrote:
>
> On Tuesday, September 30, 2008, at 01:09PM, "Nick Zitzmann" <email@hidden> wrote:
>>
>>On Sep 30, 2008, at 2:02 PM, David wrote:
>>
>>> Except that it only does it for a debug build. For the release build
>>> it reverted back to the old name.
>>>
>>> What gives? I can't figure out why its doing this.
>>
>>
>>Are you sure you have your product name in sync across configurations?
>>In the target's build tab, if you change the configuration to "all
>>configurations", what happens to the product name?
>>
> I would check 3 places:
> - Under Target Info:
> (1) Check the "General" name
> (2) Check the "Build", "Product" name
>
> - Under the Executables section (bottom, left of an Xcode project), check to make sure that it has the correct name. Usually the "General" name syncs to the "Executable" name, but not always.
>
> Mark
> _______________________________________________
>
> Cocoa-dev mailing list (email@hidden)
>
> Please do not post admin requests or moderator comments to the list.
> Contact the moderators at cocoa-dev-admins(at)lists.apple.com
>
> Help/Unsubscribe/Update your Subscription:
>
> This email sent to email@hidden
>
_______________________________________________
Cocoa-dev mailing list (email@hidden)
Please do not post admin requests or moderator comments to the list.
Contact the moderators at cocoa-dev-admins(at)lists.apple.com
Help/Unsubscribe/Update your Subscription:
This email sent to email@hidden