Monitor Banding (Part 2 of 2)
Monitor Banding (Part 2 of 2)
- Subject: Monitor Banding (Part 2 of 2)
- From: Armand Rosenberg <email@hidden>
- Date: Fri, 21 Dec 2001 10:48:26 -0500
Does anyone know if the Mitsubishi Diamond Pro 920 and 2060u monitors
are able to accept the DDC/2C signals, and hence are candidates for
Sequel's cable described below?
Thank you,
Armand
At 5:39 PM -0800 12/20/01, email@hidden wrote:
This was a prime
factor in Sequel's decision to develop the Enable Cable to aid in automating
the display adjustment functions by addressing the DDC/2C compliant controls
within the monitor. The dark point is set based upon the desired gamma,
maximum luminance and knowledge of other factory parameters. The use of
this adjustment capability is extended to the RGB bias controls as well. The
RGB bias controls interact with the RGB gammas so it is necessary to iterate
these adjustments. These are adjustments that cannot happen using "PreCal"
sort of operations from the front panel, the on screen display perturbs the
display and it prevents reliable measurement of the dark regions.