Re: Optical + ICC profile = "boxed cursor"?
Re: Optical + ICC profile = "boxed cursor"?
- Subject: Re: Optical + ICC profile = "boxed cursor"?
- From: Steve Upton <email@hidden>
- Date: Thu, 17 Jan 2002 15:05:50 -0800
At 6:21 PM -0700 1/15/02, Don Dennis wrote:
>
I seem to remember some discussion a while back about the cursor going
>
"boxy" after using OptiCal to profile the monitor. I didn't pay that
>
close attention, because I'd been using the Spyder for a few months
>
without that problem. Well...
>
>
I now have a "boxed" cursor, if a slight ghosted red square (about 1/2"
>
sq.) hanging off the bottom right of the cursor, is what everyone means
>
by that term.
>
>
If I go into the Monitors Control Panel and pick a different profile,
>
the box vanishes. But then, that defeats the purpose of having OptiCal,
>
doesn't it.
>
>
What was the consensus as to the cause/solution... a conflicting
>
extension? OptiCal loading at startup? Something else.
Running the software update control panel should take care of it.
We have a summary of the problem here:
<
http://www.chromix.com/colorsmarts/smartnotes/smartNote.cxsa?snid=1001>
Regards,
Steve Upton
________________________________________________________________________
o Steve Upton CHROMiX www.chromix.com
o (hueman) 866.CHROMiX
o email@hidden 206.985.6837
o
o ColorGear ColorThink ColorValet ColorSmarts ProfileCentral
________________________________________________________________________
--