Re: Monaco EZcolor 2.5 with Lacie electron blue 22
Re: Monaco EZcolor 2.5 with Lacie electron blue 22
- Subject: Re: Monaco EZcolor 2.5 with Lacie electron blue 22
- From: carlolavatori <email@hidden>
- Date: Thu, 12 Jun 2003 14:52:35 +0200
On Mercoledl, giu 11, 2003, at 16:43 Europe/Rome, Owen Daily wrote:
--
Firstly, thanks to Roger and Mark for emailing me some tips so quickly.
Roger wrote:
You need to increase the Brightness to around a value of 40 to 60 to
make
Monaco happy (same with lots of others). Contrast controls the global
luminance of the monitor, so a 100% value is OK as long as you don't
feel
dazzled by your screen and Monaco is not going to complain about that.
But
the black point (Brightness) is another story. Restart the procedure
but
this time set your Brightness down to 30% to begin with and increase it
until Monaco is happy.
I followed these instructions as best as I could, i.e. for
- Lightest black measurement Contrast 100% & Brightness 100%
- Darkest Black measurement Contrast to 100%, brightness down to 30%
and from there I stepped up in 10% increments right up to 100%. I
also tried with a starting contrast of 60% and then changing the
brightness incrementally to see if that would make any difference
without success. Each time I would get the message that the black was
too low and out of range of the colorimeter - even at 100% for both
brightness and contrast.
Incidentally I tried testing my own cheap monitor at home and the
software and colorimeter took me through the steps without a hitch.
This beautiful high-end LaCie monitor has more settings than I know
what to do with.
Any more advice folks? For your info the monitor is set at the moment
on:
IN OSD order
Brightness 100%
Contrast 100
Color Mode 2
R = 77, G = 67, B, 59 6500K
Fine Picture mode - normal
Thanks
Owen Daily
_______________________________________________
I have the same exact problem as you do!
and is quite annoying having just bought Monaco EZcolor with Monaco
Optix...
let me know if you find a solution...
I have been in contact with Monaco support about it and they suggested
to do just as Roger wrote (actually they quoted Roger exact words,
which was kind of funny) , which I did, but even at 100 % brightness I
got the message that the black was too low and out of range of the
colorimeter.
My OSD in my LaCie 22blueIII is set pretty much like yours:
I keep my Brightness at 85% after having done the manual adjustment
through the EZcolor interface and I was just wondering why my RGB value
in color 2 are different from yours
Mine:
6500K
R 71% G 53% B 44%
after having reset everything at factory preset
and about FPM at this point I don't know what to do since you cannot
turn it off
Color management!
What a wonderful world!
Thanks to everybody for their help
Carlo
----
www.carlolavatori.com
----
_______________________________________________
colorsync-users mailing list | email@hidden
Help/Unsubscribe/Archives:
http://www.lists.apple.com/mailman/listinfo/colorsync-users
Do not post admin requests to the list. They will be ignored.