Re: ProfileMaker 5 won't read a strip
Re: ProfileMaker 5 won't read a strip
- Subject: Re: ProfileMaker 5 won't read a strip
- From: Matt Nelson <email@hidden>
- Date: Tue, 22 Mar 2005 17:31:30 -0600
Well what I've done is send charts to GMB, and they are going to read
them and see if my charts are bad or not. I can read past line 6 on
another target previously read, and on this target on two different Macs,
I can read some strips and not others. I've gotten past 6 a few
times, then not been able to read 7, read 8, not 9, etc. Sounds
like a hardware problem until I try to read another older chart and it
works. Makes no sense at all.
--
Matt
At 02:13 PM 3/22/2005 -0500, you wrote:
One more
tip
.
if your click the measure button on the eye one once (not start
measuring) and then give it a try it sometimes helps. So:
-press eye one button and wait for
tone
-release button
-wait a few seconds
-press button again and hold and wait for
tone
-start moving eye one
This was advice given to me for using the i1 with GMGs ProfileEditor, so
I cant say if it will help you or not
cant hurt.
mike
--
Matt Nelson, A+, Network +, MCP
Prepress Production Manager
Director of Technology Resources
Nelson Printing Company
Nelson Label Company
Jonesboro, Arkansas
email@hidden
http://www.nelsonprinting.com
_______________________________________________
Do not post admin requests to the list. They will be ignored.
Colorsync-users mailing list (email@hidden)
Help/Unsubscribe/Update your Subscription:
This email sent to email@hidden