Re: iCColor vs DTP70
Re: iCColor vs DTP70
- Subject: Re: iCColor vs DTP70
- From: Marco Ugolini <email@hidden>
- Date: Wed, 28 Feb 2007 12:04:44 -0800 (GMT-08:00)
In a message dated Feb 28, 2007 11:44 AM, Andrew Rodney wrote:
>On 2/28/07 12:03 PM, "Fleisher, Ken" wrote:
>
>> The ICColor only makes colorimetric measurements, so if you require spectral
>> measurements it won¹t suit your needs. I¹d personally stick with the i1Pro if
>> it was me...
>
>You sure about this? I used the iCColor for a good year or two and built a
>lot of profiles and if memory serves me, I was able to use the spectral
>functionality in ProfileMaker Pro.
It is a spectrophotometer, which means that it is capable of spectral readings.
To quote from page 33 of the PDF manual (available at <http://www.xrite.com/documents/literature/gmb/en/200_iccolor_manual_en.pdf>):
***
Reflection Measurement System
Measurement Technology
• Spectral analysis: Holographic diffraction grating
• Spectral range: 380 – 730 nm
• Physical resolution: 10 nm continuous (internal sampling rate 3.3 nm)
• Measurement geometry: 45º/0º ring optics
• Measurement aperture: Ø 4.5 mm
• Light source: Gas-filled tungsten, type A illumination
[...]
Measurement Modes
• Colorimetry: CIE L*a*b*, CIE L*C*h, CIE XYZ
• Densitometry: Density
• Spectra: Reflectance spectrum
[...]
Transmission Measurement System
Measurement technology
• Measurement geometry: Specular/diffuse (0/d)
• Measurement aperture: Ø 3 mm
• Light source: Gas-filled tungsten, type A illumination
_______________________________________________
Do not post admin requests to the list. They will be ignored.
Colorsync-users mailing list (email@hidden)
Help/Unsubscribe/Update your Subscription:
This email sent to email@hidden