Re: Interesting monitor calibration discovery department
Re: Interesting monitor calibration discovery department
- Subject: Re: Interesting monitor calibration discovery department
- From: "Bob Frost" <email@hidden>
- Date: Tue, 28 Jul 2009 08:59:37 +0100
- Importance: Normal
So the verdict is in: for the utmost quality in
calibration and profiling with the EyeOnePro, in direct contact with the
screen, give it ample time to warm up to the display.
I found some years ago that when reading printer profile patches with my
i1Pro the readings slowly went up as the i1Pro warmed up. If I read the same
white patch again and again, the readings slowly increased up to about 100
readings and then levelled off. If I slowed down the rate of reading to one
every four seconds, that minimised the increase, so I settled on making 20
readings of the same white patch to warm the device up and then immediately
taking the real readings at the rate of one every four seconds. I also took
20 readings of the white patch at the end to compare with the initial 20
readings.
So yes, temperature increases affect the i1Pro both for monitor profiling as
pointed out by Roger and others, and for patch reading. I haven't tested to
see what happens to temperature when reading patches in scanningmode.
Bob Frost.
--------------------------------------------------
From: "Roger" <email@hidden>
_______________________________________________
Do not post admin requests to the list. They will be ignored.
Colorsync-users mailing list (email@hidden)
Help/Unsubscribe/Update your Subscription:
This email sent to email@hidden