Re: Get audio from Firewire
Re: Get audio from Firewire
- Subject: Re: Get audio from Firewire
- From: Robert Grant <email@hidden>
- Date: Sat, 8 Feb 2003 12:42:23 -0500
Search the archives. This has been discussed and FireWire audio,
because it's part
of the DV stream from the camera, is not automatically supported by HAL.
Robert.
On Saturday, February 8, 2003, at 10:36 AM, Gilbert Mackall wrote:
David,
I connect my Canon ZR10 DV camera via Firewire to my G4. I put the
camera in VCR mode and start play back of a movie. After wait a few
minutes, I look under System Preferences Sound, Inputs. I don't see
the camera listed, I run my application and it does not see it as > well.
Assuming everything is setup correctly, you should see the camera
just fine. If you want to make sure, you can try Sound Studio, I know
that it shows a DV device for input (even without one connected!). So
you may want to make sure that your search code is correct & that
your camera is in the right mode. I'm sure if you post to the list
someone can point out an error (unfortunately, I myself haven't
written capture code, I just know the CoreAudio architecture).
--
Reality is what, when you stop believing in it, doesn't go away.
Failure is not an option. It is a privilege reserved for those who
try.
Gilbert Mackall
N3RZN
_______________________________________________
coreaudio-api mailing list | email@hidden
Help/Unsubscribe/Archives:
http://www.lists.apple.com/mailman/listinfo/coreaudio-api
Do not post admin requests to the list. They will be ignored.
_______________________________________________
coreaudio-api mailing list | email@hidden
Help/Unsubscribe/Archives:
http://www.lists.apple.com/mailman/listinfo/coreaudio-api
Do not post admin requests to the list. They will be ignored.