Re: Convert a pkg installer to a flat package installer?
Re: Convert a pkg installer to a flat package installer?
- Subject: Re: Convert a pkg installer to a flat package installer?
- From: Bob Sellon <email@hidden>
- Date: Fri, 12 Feb 2010 20:47:26 -0500
Actually, the other way round. Set it for 10.5 (for the PackageMaker).
On Feb 12, 2010, at 8:42 PM, Bob Sellon wrote:
> I only recently discovered the Project/Raw Editing Mode so I haven't had a chance to check this but if you set the "Minimum Target" under Project/Install Properties.. to v10.4, it is supposed to switch to the non-flat format.
>
>
> On Feb 12, 2010, at 8:31 PM, Don Montalvo wrote:
>
>> On Feb 12, 2010, at 7:29 PM, Don Montalvo wrote:
>>
>>> Is it possible to convert a standard pkg installer > flat pkg installer?
>>>
>>> I'm looking through Apple's (and of course Sudre's) documentation but don't see any way to do this.
>>>
>>> Thanks,
>>> Don
>>
>> ...a follow up question. If conversion is not possible, is it feasible to create a new project, import our existing pkg installer, then save as a flat pkg?
>>
>> PS, Sudre, please point me to your PayPal page.... :):):)
>>
>> Thanks,
>> Don _______________________________________________
>> Do not post admin requests to the list. They will be ignored.
>> Installer-dev mailing list (email@hidden)
>> Help/Unsubscribe/Update your Subscription:
>>
>> This email sent to email@hidden
>>
>
> _______________________________________________
> Do not post admin requests to the list. They will be ignored.
> Installer-dev mailing list (email@hidden)
> Help/Unsubscribe/Update your Subscription:
>
> This email sent to email@hidden
>
_______________________________________________
Do not post admin requests to the list. They will be ignored.
Installer-dev mailing list (email@hidden)
Help/Unsubscribe/Update your Subscription:
This email sent to email@hidden