Re: Cannot start XQuatrz after installation
Re: Cannot start XQuatrz after installation
- Subject: Re: Cannot start XQuatrz after installation
- From: Pasquale-Fabrizio Salvatore <email@hidden>
- Date: Thu, 27 Jul 2017 15:06:24 +0100
Hi Tom,
You were absolutely right. Rebooting after installation solved the issue.
Best wishes,
Fab
--
+++++++++++++++++++++++++++++++++++++++++++++++
Dr Fabrizio Salvatore | e-mail: email@hidden
orcid.org/0000-0002-3709-1554
Department of Physics and Astronomy, University of Sussex,
Brighton, Sussex, BN1 9QH, United Kingdom
Tel.: +44 (0)1273 67 8749; Fax: +44 (0)1273 67 8068
http://epp.phys.susx.ac.uk/epp/FabrizioSalvatore
facebook.com/p.fabrizio.salvatore
+++++++++++++++++++++++++++++++++++++++++++++++
> On 26 Jul 2017, at 16:45, Tom Lane <email@hidden> wrote:
>
> Pasquale-Fabrizio Salvatore <email@hidden> writes:
>> I have just installed XQuartz on a new MacBook 12’’. I have the reassuring
>> message that the installation has gone OK, but then when I launch it the
>> icon will ‘jump’ for a while and then stop, but I cannot see the xterm and I
>> cannot see XQuartz program when I do 'Command-Tab’.
>
> If memory serves, this is what happens in a fresh installation if you
> don't log out and back in again afterwards.
>
> If that's not it, I'm unqualified to help further :-( ...
>
> regards, tom lane
_______________________________________________
Do not post admin requests to the list. They will be ignored.
X11-users mailing list (email@hidden)
Help/Unsubscribe/Update your Subscription:
This email sent to email@hidden