Remeasuring specific patches in a testchart [was: Spectros not measuring the same]
Remeasuring specific patches in a testchart [was: Spectros not measuring the same]
- Subject: Remeasuring specific patches in a testchart [was: Spectros not measuring the same]
- From: Marco Ugolini <email@hidden>
- Date: Sat, 16 Jan 2010 13:23:09 -0800
- Thread-topic: Remeasuring specific patches in a testchart [was: Spectros not measuring the same]
In a message dated 1/16/10 11:43 AM, Simon ONeill wrote:
> I have not yet discovered why the instrument sometimes messes up (only) a
> single patch, but have found that remeasuring the offending patch (in patch
> mode) always gives a repeatable result.
That is good advice, Simon. Thank you.
One question: when comparing multiple measurement sets of, say, an
ECI2002CMYK testchart, the measurement files show up in MeasureTool's
"Comparing" window as ECI 2002 visual, which is not the order in which the
patches were measured.
So, if for example there is a high DeltaE 2000 value for patch L41 in the
ECI 2002 visual file, how do I find out which exact patch corresponds to it
in my measurement file, since the x/y coordinates no longer match between
the two due to the changed layout?
Does anyone have a quick way to make that translation? Without it, there is
no way to know which exact patch(es) to remeasure in MeasureTool's chart
measuring tool.
Marco
_______________________________________________
Do not post admin requests to the list. They will be ignored.
Colorsync-users mailing list (email@hidden)
Help/Unsubscribe/Update your Subscription:
This email sent to email@hidden