Re: (no subject)
Re: (no subject)
- Subject: Re: (no subject)
- From: email@hidden
- Date: Tue, 23 Jan 2001 08:03:32 EST
In a message dated 1/23/01 2:31:08 AM, email@hidden writes:
>
Problem 1\ A tone is appearing in the whites of prints on the Epson7500
>
>
using paper profiles I created using Profilemaker 3.1. It doesn't seem
>
to
>
matter what reference profile I use. The tone only appears when I print
>
the job with a reference profile installed, if I print the job using only
>
the paper profile the tone does not appear.
>
If I am using one of the Bestcolor supplied paper profiles the tint goes
>
>
away.
Sounds like you need to manually edit the whitepoint of your profile...
>
>
Problem 2\ Printing a job using a custom paper profile I created using
>
=
>
Profilemaker 3.1 and any reference profile the colours are looking a =
>
little flat especially the yellow. The yellow is coming out very very =
>
dirty and I am unable to make any improvements using Gretags Profile =
>
Editor.
>
The tone only appears when I print the job with a reference profile install=
>
ed, if I print the job using only the paper profile the yellows are clean.
>
If I using one of the BestColor supplied paper profiles the yellow prints
>
=
>
correctly when using a ref profile.
If dirty means fine black speckles over the yellow, then I would guess the
issue might be blacks polluting your lighter tones. Try building a profile
with the black start set above 50% and see if this goes away.
C. David Tobie
Design Cooperative
email@hidden