Re: Using DTP41 to read densities
Re: Using DTP41 to read densities
- Subject: Re: Using DTP41 to read densities
- From: "Adriano Von Markendorf" <email@hidden>
- Date: Sun, 10 Feb 2002 12:19:15 -0300
>
I have the need to read the densities of a 21 step gray scale in CMYK.
>
Currently we are reading one square at a time and writing them down.
>
This is very time consuming.
>
Is there a software for the DTP 41 that will let me read a standard 21
>
step scale and print out the densities?
>
By 21 step I mean, 0 - 100 in 5 percent increments.
>
>
Or, is there s/w that will let me create my own scale and have the DTP
>
read it and print out the values?
I'm not sure if I get your point, anyway, the ToolCrib (come together DTP41
combo)
It's an application that will be able to do that job.
If you need information about ToolCrib procedures, let me know.
A little bit boring but, low cost and much faster either your actual
procedures.
Well, did you have any profiling suite?
eg. ProfileMaker/ColorBlind/ColorVision.
Adriano von Markendorf email@hidden
"I-C-Cm vitamin's inside" Rio de Janeiro - Brazil
_______________________________________________
colorsync-users mailing list | email@hidden
Help/Unsubscribe/Archives:
http://www.lists.apple.com/mailman/listinfo/colorsync-users
Do not post admin requests to the list. They will be ignored.