Re: Color target fitting to press
Re: Color target fitting to press
- Subject: Re: Color target fitting to press
- From: Jim Rich <email@hidden>
- Date: Fri, 17 Dec 2004 15:46:09 -0500
On 12/17/04 3:13 PM, "Matt Nelson" <email@hidden> wrote:
>
>
>
> I'm using the IT8/7.3 target to profile my Epson 7600, Dot proofer, and my
> two MarkAndy 2200 flexo presses, 7" and 10" max web widths.
>
> Problem is such, the target will just fit the 10" 2200, but the 7" is too
> narrow (I have cylinders big enough to fit the target depthwise.) What
> would be the best way to get around this? Can the target be
> shrunk? Should I split it and run half at a time, the tape the halves
> back together to read them
Matt,
What hardware and software tools do you have?
There are a few different strategies for this. Here are two.
One is that if you have a Gretag Spectrolino Spectrascan xy table. This let
you reduce the target size as long as you don¹t make each patch to small to
measure.
The other method is to use a tool like the Gretag ProfileMaker target
generator to make custom printer patches based on the size of your output
device.
Jim Rich
_______________________________________________
Do not post admin requests to the list. They will be ignored.
Colorsync-users mailing list (email@hidden)
Help/Unsubscribe/Update your Subscription:
This email sent to email@hidden