Re: Problems with Atkinson profiles on an Epson 9600
Re: Problems with Atkinson profiles on an Epson 9600
- Subject: Re: Problems with Atkinson profiles on an Epson 9600
- From: Scott Martin <email@hidden>
- Date: Fri, 09 Sep 2011 01:16:15 -0500
Hey Tim. Your situation is common. These printers do change over time - especially after heavy usage. All you need to do is make a fresh set of custom profiles. If made well you'll see better results than ever.
Scott Martin
www.on-sight.com
On Sep 8, 2011, at 10:48 PM, Tim Vitale wrote:
> In the past I have always found Bill Atkinson's "9600 profiles" to be the
> answer to my problems.
>
> Recently I have been getting very dark results. I have tried many
> solutions, not the least of which, was to use PM4.1 Profile Editor to make
> "Global Correction" lightening of the profile itself. While this has some
> value, it is not "good" and I've never needed to go this direction before.
> I have even tried the profiles Epson shipped with the printer; no joy there
> as you might imagine. The results were even darker.
>
> I have begun to wonder if my printer could just be "darkening" everything.
> This does not seem to make sense. Has anyone run into this?
>
> The machine had new heads and a general tune-up about 2 years ago.
>
> TX
>
> Tim Vitale
> Paper and Photographs Conservator
> Oakland, CA
> 510-594-82877
>
>
> _______________________________________________
> Do not post admin requests to the list. They will be ignored.
> Colorsync-users mailing list (email@hidden)
> Help/Unsubscribe/Update your Subscription:
>
> This email sent to email@hidden
_______________________________________________
Do not post admin requests to the list. They will be ignored.
Colorsync-users mailing list (email@hidden)
Help/Unsubscribe/Update your Subscription:
This email sent to email@hidden