Re: Strange strip reading results in EFI eXpress/EFI XF
Re: Strange strip reading results in EFI eXpress/EFI XF
- Subject: Re: Strange strip reading results in EFI eXpress/EFI XF
- From: Kamil Tresnak <email@hidden>
- Date: Mon, 22 Jul 2013 16:34:21 +0200
Hi all,
thank you Terence, Claas, Michael, Raimar and Karl for valuable input. It seems reasonable that there may be a link with the difference in measurements by GMDI (Express) and XRDA (XF). I'll try it and will post the result.
Regards,
Kamil
______________________________________________________________
> Od: "Karl Koch" <email@hidden>
> Komu: <email@hidden>
> Datum: 22.07.2013 09:35
> Předmět: Re: Strange strip reading results in EFI eXpress/EFI XF
>
> CC: "Terence Wyse" <email@hidden>
>Hi Kamil,
>
>I´d rather check the calibration standards used for the i1 in XF vs. eXpress.
>The original 1i Pro was calibrated to the so called GMDI standard. (Long) after the merger/acquisition, X-Rite and GMB unified their previously different calibration standards and hyped it as the new industry standard named XRGA (brilliant marketing, BTW).
>Still, your differences seem a bit large because the difference induced by the different calibration standards should be less than DeltaE 2. But if your deviation from the reference and the calibration differences point in the same direction, different calibrations are not to be ruled out as the cause of these relatively huge differences.
>You´have to check with EFI, which i1 drivers they are using in their software.
>
>Karl
>
>Am 19.07.2013 um 18:51 schrieb Terence Wyse <email@hidden>:
>
>> Same strip.....but you must have two different sets of references......either that or your strip is changing by a HUGE amount due to dry-back. Print 2 copies of the strip, wait for exactly the same amount of time before measuring.
>>
>> What printers and media are you using?
>>
>> terry
>>
>>
>> On Jul 19, 2013, at 12:06 PM, Kamil Tresnak <email@hidden> wrote:
>>
>>> sorry if due to my english i was not accurate ... this is ONE strip, physically just one piece, which i am measuring in both applications - in few minutes, with same device and same others conditions, standards etc ... just curious, how can be measurements soooo different????
>>
>>
>> _______________________________________________
>> Do not post admin requests to the list. They will be ignored.
>> Colorsync-users mailing list (email@hidden)
>> Help/Unsubscribe/Update your Subscription:
>>
>> This email sent to email@hidden
>
>
_______________________________________________
Do not post admin requests to the list. They will be ignored.
Colorsync-users mailing list (email@hidden)
Help/Unsubscribe/Update your Subscription:
This email sent to email@hidden