Re: How to cut silence away from the beginning of output signal
Re: How to cut silence away from the beginning of output signal
- Subject: Re: How to cut silence away from the beginning of output signal
- From: William Stewart <email@hidden>
- Date: Mon, 9 May 2005 15:30:48 -0700
You should declare that latency of your AU to be 1 second then I think.
Bill
On 07/05/2005, at 4:05 AM, Giovanni Salerno wrote:
Hi there.
I'm working on an AU plug-in that starts to output the processed
signal after about a second. So at the end of processing I get what
I want, except for that second of silence.
I've tried with AudioUnitRenderActionFlags, setting it to
kAudioUnitRenderAction_OutputIsSilence until the processed signal
is ready for the output: no way.
Any solution?
Thank you. Bye.
Giovanni
_______________________________________________
Do not post admin requests to the list. They will be ignored.
Coreaudio-api mailing list (email@hidden)
Help/Unsubscribe/Update your Subscription:
This email sent to email@hidden
--
mailto:email@hidden
tel: +1 408 974 4056
________________________________________________________________________
__
"Much human ingenuity has gone into finding the ultimate Before.
The current state of knowledge can be summarized thus:
In the beginning, there was nothing, which exploded" - Terry Pratchett
________________________________________________________________________
__
_______________________________________________
Do not post admin requests to the list. They will be ignored.
Coreaudio-api mailing list (email@hidden)
Help/Unsubscribe/Update your Subscription:
This email sent to email@hidden