Re: mp3 to aiff using extended audio file
Re: mp3 to aiff using extended audio file
- Subject: Re: mp3 to aiff using extended audio file
- From: William Stewart <email@hidden>
- Date: Fri, 13 Jan 2006 18:17:10 -0800
It can't be - if you are using CoreAudio to do this, we don't have
any pieces in 10.4.4 that would fix this (or come anywhere near
this). Why do you think this is fixed?
Can you send me a binary or code, that I can run to verify this?
Thanks
Bill
On 13/01/2006, at 9:06 AM, Tim Bartoo wrote:
Hi,
FYI, the problem I reported a week or so ago is fixed in 10.4.4.
Tim
Hi,
I'm using the extended audio file api to attempt to convert mp3 to
aiff (48kHz, 16 bit). My code works fine if the input file is PCM,
but with mp3 the routine runs for a few seconds, and generates 3
or 4 MB for output data, then gets an access error in
MP3AudioFile::GetContiguousPacketCountAndSize, aways up the call
stack from my call to ExtAudioFileRead. To trouble-shoot, I am
only trying to read and write one packet at a time.
Anyone have similar experience and / or solutions?
Thanks,
Tim Bartoo
_______________________________________________
Do not post admin requests to the list. They will be ignored.
Coreaudio-api mailing list (email@hidden)
Help/Unsubscribe/Update your Subscription:
This email sent to email@hidden
--
mailto:email@hidden
tel: +1 408 974 4056
________________________________________________________________________
__
"Much human ingenuity has gone into finding the ultimate Before.
The current state of knowledge can be summarized thus:
In the beginning, there was nothing, which exploded" - Terry Pratchett
________________________________________________________________________
__
_______________________________________________
Do not post admin requests to the list. They will be ignored.
Coreaudio-api mailing list (email@hidden)
Help/Unsubscribe/Update your Subscription:
This email sent to email@hidden