assign-address is failing in open-firmware
assign-address is failing in open-firmware
- Subject: assign-address is failing in open-firmware
- From: "Rakesh Singhal" <email@hidden>
- Date: Wed, 1 Nov 2006 14:01:20 +0530
Hi all
I'm testing a Fcode program for a PCI card. I've created "reg" property inside my fcode. But after I create a package, assign-addresses is failing to create "assigned-address" property on G3 machine giving an error "Can't allocate address space". However, there is no problem on a G4 machine where I can successfully test my code.
The only difference that I see is, the pci card node pciAAAA,BBBB is getting created under /pci on a G4 while on G3 its under /pci/pci-bridge. Is there anything special to be done if the pci card node in under a bridge as far as assign-addresses is concerned?
Any help would be appreciated.
Thanks
_______________________________________________
Do not post admin requests to the list. They will be ignored.
Darwin-kernel mailing list (email@hidden)
Help/Unsubscribe/Update your Subscription:
This email sent to email@hidden