Re: FxPlug SDK 1.2.4 build issues
Re: FxPlug SDK 1.2.4 build issues
- Subject: Re: FxPlug SDK 1.2.4 build issues
- From: Paul Schneider <email@hidden>
- Date: Thu, 20 Aug 2009 15:31:50 -0500
Hi Steve,
We didn't intentionally increase our OS or XCode requirements, but
this may have happened inadvertently. Can you send the full build
transcript with the linker errors? You can just send it to me rather
than the whole list.
- Paul
On Aug 20, 2009, at 3:00 PM, Steve Christensen wrote:
I just downloaded and installed the FxPlug 1.2.4 SDK. When I tried
to rebuild some existing projects, I was getting "unknown load
command" linker errors. When I backed down to the 1.2.3 SDK, the
build worked as expected.
I did the build on a 10.4.11 system running Xcode 2.5. (My plugins
run on 10.4.x and later so I prefer to build/test in that
configuration.)
I suspect the issue to be either that 1.2.4 expects 10.5 and/or the
linker commands are only valid for Xcode 3.x. I looked through both
the 1.2.4 ReadMe and the SDK Overrview PDF but didn't see any build/
runtime restrictions. If there is at least a minimum OS requirement
for the 1.2.4 SDK, the installer should do a check and refuse to
install on earlier systems.
Any thoughts?
steve
_______________________________________________
Do not post admin requests to the list. They will be ignored.
Pro-apps-dev mailing list (email@hidden)
Help/Unsubscribe/Update your Subscription:
This email sent to email@hidden
_______________________________________________
Do not post admin requests to the list. They will be ignored.
Pro-apps-dev mailing list (email@hidden)
Help/Unsubscribe/Update your Subscription:
This email sent to email@hidden