Hi!
I installed xquartz 2.3.0 in order to run Gimp na Mac OS
10.5.4. (GIMP would not start with default X11). Note that wireshark was running fine with the stock installation of X11. Or at least I think so.
When I upgaraded to 2.3.0, X11.app would start, but without window borders (I could not move windows, could not close them...) I "downgraded" do 2.2.3 by deleting X11 from Application/Utilities and installing 2.2.3 afterwards. Now X11.app wouldn't even start. (I guess that was not such a good idea)
So I removed it again, installed again 2.3.0 and figured that it must the WM I am missing. When X11 is launched, quartz-wm is not. So I launched it by hand.
Sometimes it starts OK, and sometimes it ends abrtuptly. With no apparent pattern. When I launch xterm or gimp now, I get all the borders and everything. Sometimes, when I just hover over it with my mous, it disappears immediately.
Obviously, there is something wrong with the X11 launcher, because it does not start the quartz-wm. Where can I configure that, so that it runs?
My .xinitrc is empty.
Any ideas what I can look at? Are there some diagnostic tools which I could run?
Thanks,
Miha