Little correction in profile - How to do it?
Little correction in profile - How to do it?
- Subject: Little correction in profile - How to do it?
- From: "Lists" <email@hidden>
- Date: Fri, 18 Jan 2002 14:45:07 +0100
Hi,
I've made a profile of our offset press with the Gretag Software.
The profile is not bad, but we see a little problem in the light tones.
I simulate our press on a Epson 5000, and see that in the light tones,
there is a little bit too much magenta in it.
All the other colors (darker) aren't bad, only the light ones.
I know that there is a tool to change a little bit the profile (Profile
editor), but when I use this, I loose the control over my profile.
It's very difficult to do something correct, because I loose then some
quality at the opposite site.
Can anyone help me out how I can change this magenta tone?
Best regards,
Bart M.