Re: Green cast on Monitors after calibration
Re: Green cast on Monitors after calibration
- Subject: Re: Green cast on Monitors after calibration
- From: email@hidden
- Date: Thu, 1 May 2003 09:30:21 EDT
In a message dated 4/30/03 9:36:40 PM, email@hidden writes:
>
After using Optical 3.7.5 and an Xrite dtp-92 densitometer to calibrate a
>
monitor (Sony Multiscan G420) I find the display has a noticeable green
>
cast. This happens quite regularly, some times more noticeable than others.
>
>
I have heard people say in the past that properly calibrated displays do
>
have a green look to them.
>
>
Is this the same in everyone else's experience?
>
If this is the case is there any documentation anywhere about this?
>
No, your monitor should not look green after calibration. Since there is no
commonly known issue about this with the DTP92, you should go through the
whole troubleshooting process with ColorVision tech support <
email@hidden>. But first, try selecting MonitorRGB as your
workingspace (temporarily only!). If its still green with this selected, its
likely the monitor itself is short on red (perhaps in precalibration of the
guns, or else the red gun is wearing out); if this makes the cast go away,
its probably somewhere in the settings, software, or DTP92, and tech support
is your best bet of finding out where.
C. David Tobie
Design Cooperative
email@hidden
_______________________________________________
colorsync-users mailing list | email@hidden
Help/Unsubscribe/Archives:
http://www.lists.apple.com/mailman/listinfo/colorsync-users
Do not post admin requests to the list. They will be ignored.