Re: Green cast on Monitors after calibration
Re: Green cast on Monitors after calibration
- Subject: Re: Green cast on Monitors after calibration
- From: "Adriano Von Markendorf" <email@hidden>
- Date: Thu, 1 May 2003 10:56:54 -0300
>
In a message dated 4/30/03 9:36:40 PM, writes:
>
>
>
> After using Optical 3.7.5 and an Xrite dtp-92 densitometer to calibrate
a
>
> monitor (Sony Multiscan G420) I find the display has a noticeable green
>
> cast. This happens quite regularly, some times more noticeable than
others.
>
>
>
> I have heard people say in the past that properly calibrated displays do
>
> have a green look to them.
>
>
>
> Is this the same in everyone else's experience?
>
> If this is the case is there any documentation anywhere about this?
Mr. Tobie reply:
>
No, your monitor should not look green after calibration. Since there is
no
>
commonly known issue about this with the DTP92, you should go through the
>
whole troubleshooting process with ColorVision tech support <
>
email@hidden>. But first, try selecting MonitorRGB as your
>
workingspace (temporarily only!). If its still green with this selected,
its
>
likely the monitor itself is short on red (perhaps in precalibration of
the
>
guns, or else the red gun is wearing out); if this makes the cast go away,
>
its probably somewhere in the settings, software, or DTP92, and tech
support
>
is your best bet of finding out where.
Maybe sound too obvious, anyway...
Could you check your startup folder and try find any Adobe Gamma loader
shortcut?
And after that, recheck with "MSCONFIG" > Startup .... all startup itens and
try to find any iten (AdobeGamma, VideoLoader startup, Logo. etc) checked.
Regards,
Adriano von Markendorf email@hidden
"I-C-Cm vitamin's inside" Rio de Janeiro - Brazil
_______________________________________________
colorsync-users mailing list | email@hidden
Help/Unsubscribe/Archives:
http://www.lists.apple.com/mailman/listinfo/colorsync-users
Do not post admin requests to the list. They will be ignored.