Re: Green cast on Monitors after calibration
Re: Green cast on Monitors after calibration
- Subject: Re: Green cast on Monitors after calibration
- From: Glenn McCarter <email@hidden>
- Date: Fri, 02 May 2003 12:21:22 +1000
Thanks for the tips everyone.
I ended up resetting the monitor back to the factory defaults and then
recalibrating. The result after that was much better.
on 1/5/03 11:30 PM, email@hidden wrote:
>
No, your monitor should not look green after calibration. Since there is no
>
commonly known issue about this with the DTP92, you should go through the
>
whole troubleshooting process with ColorVision tech support <
>
email@hidden>. But first, try selecting MonitorRGB as your
>
workingspace (temporarily only!). If its still green with this selected, its
>
likely the monitor itself is short on red (perhaps in precalibration of the
>
guns, or else the red gun is wearing out); if this makes the cast go away,
>
its probably somewhere in the settings, software, or DTP92, and tech support
>
is your best bet of finding out where.
>
>
C. David Tobie
>
Design Cooperative
>
email@hidden
>
--
Glenn McCarter
_______________________________________________
colorsync-users mailing list | email@hidden
Help/Unsubscribe/Archives:
http://www.lists.apple.com/mailman/listinfo/colorsync-users
Do not post admin requests to the list. They will be ignored.