Re: Offset plate tone value tolerance
Re: Offset plate tone value tolerance
- Subject: Re: Offset plate tone value tolerance
- From: Martin Weberg <email@hidden>
- Date: Thu, 7 May 2009 23:19:48 +0200
Jon,
Thanks for your input.
2009/5/7 Jon Crook <email@hidden>:
> +/- 1.5% on a 3% tint is very noticeable but not on a 30% tint. Our
> tolerance is the tolerance of the reader. We print on only a #1 sheet so we
> have everything dialed in pretty close but I would expect that if you were
> printing on a multitude of papers your tolerance could be a bit larger.
> On our system I have found that the amount of variance is the same no matter
> if it is a 3% or a 50% tint which is usually within the tolerance of the
> reader. I would say that if you are using a thermal plate you should be able
> to keep your tolerance at 1% or under. If it goes above that and your not
> sure why then I would contact your plate supplier and get them involved.
Martin Weberg
_______________________________________________
Do not post admin requests to the list. They will be ignored.
Colorsync-users mailing list (email@hidden)
Help/Unsubscribe/Update your Subscription:
This email sent to email@hidden