Re: Display Calibration: Factory Reset?
Re: Display Calibration: Factory Reset?
- Subject: Re: Display Calibration: Factory Reset?
- From: neil snape <email@hidden>
- Date: Fri, 05 Feb 2010 16:12:22 +0100
- Thread-topic: Display Calibration: Factory Reset?
on 5/02/10 16:08, Pylant, Brian wrote :
> Obviously the first time you calibrate a display, you reset everything to
> the factory defaults and then follow the software instructions to make any
> necessary adjustments (color, brightness/contrast, etc.)
>
> When you re-calibrate a display (i.e. any time after the very first
> calibration) do you do a factory reset and go through the entire process of
> adjusting settings again, or do you leave everything as it was from the last
> calibration?
>
> I use an Eye One Pro and Eye One Match, and it doesn't instruct me to reset
> the display to factory defaults every time. I've done it both ways, and
> can't say I've seen a difference.
>
> Just wondering what everyone else does. Perhaps this is a silly question...
> but I like to ask them from time to time!
> :o)
>
> Brian
No you don't have to reset everything for subsequent calibrations. I just
pass right through them if using Match.
Remember the closer to the ideal default state you are in the better the
cal. It's just that sometimes the suggested defaults are not possible so you
have to assume some new settings outside of i1 Match suggestions.
Neil Snape
_______________________________________________
Do not post admin requests to the list. They will be ignored.
Colorsync-users mailing list (email@hidden)
Help/Unsubscribe/Update your Subscription:
This email sent to email@hidden